PART III-HANDLING
Power controls Aileron gear set to POWER.
Ailerons: Push selector fully forward
and move the slick later-
ally until full and free
movement is obtained;
check that the green light
comes on and the red
warning light stops flash-
ing.
Elevator: Push selector fully forward
and move the stick until
full and free movement is
obtained, check that green
light comes on and the red
warning light stops flash-
ing. Easier engagement
may result if the stick is
put fully forward before
selecting power on.
NOTE.-The red waning light will slop flashing only
when both aileron and elevator hydroboosters
are fully engaged. having been selected on. Con-
siderable force may be required to move the
stick laterally until proper engagement of the
ailerons is achieved.
Undue force should not be used to achieve
elevator engagement. It is better to select
Manual and try again with the control column in
a different position. Engagement of the powered
controls is sometimes easier at r.p.m. above 4,500.
Rudder trim Operation and set normal.
Aileron trim Operation and set neutral.
V.I. tail Check rate of operation with
T.P. INCIDENCE PRE-
SELECTOR at -4° to
-9° position (aft) using
control column switch
with speed control switch
at FAST and SLOW.
Then return PRE-
SELECTOR to +4°, -4°
position (forward). (See
para. 22(b)(v).)
Return FAST/SLOW switch
to FAST. 56
|